Hello Raj,
Yes even i got the same error when i have configured the API Connect V10 on a VMware. As a temporary solution i have done the below
1. if you have installed API Connect on a VMWare then revert back to the previous version of VM backup if you are taking VM backup on a daily basis.
2. Then run the apic command again from the same project folder to configure the backup of the subsystem.
3. Finally the updated project yaml file need to be install to the corresponding VM's.
I dont recommend this set up but it is just a temporary solution to overcome the issue.
If you were not taking the backup of VM's then you need to reconfigure everything from scratch.
Even i have tired to get it resolved without following the above but couldn't able to succeed.
Hope I have addressed your question.
Regards,
Janakiram.
------------------------------
JanakiramSudhakarKota
------------------------------
Original Message:
Sent: Thu May 06, 2021 09:41 AM
From: Jamie Witt
Subject: VM V10 Install - Issue
Do you have management backups configured? This looks like credentials were set, the doc uses "mgmt-backup-secret" as the default name for the credentials Configuring SFTP backup settings for fresh install of the Management subsystem (v10.0.1.1 or later) - IBM Documentation A VMWare install would not use that setting, Reconfiguring backup settings for the management subsystem (v10.0.1.1-eus or greater) - IBM Documentation I would check your YAML file for the mgmt system to verify the backup configuration.
------------------------------
Jamie Witt
Original Message:
Sent: Tue May 04, 2021 04:47 PM
From: Raj A
Subject: VM V10 Install - Issue
After install, I see below error for sudo apic status
Subsystem detail: Error from server (ManagementCluster.management.apiconnect.ibm.com "mgmt" is invalid: spec.datab aseBackup.credentials: Not found: "mgmt-backup-secret"): error when creating "/var/lib/apiconnect/subsystem/manifest s/28.mgmt-cr.yaml": admission webhook "vmanagementcluster.kb.io" denied the request: ManagementCluster.management.ap iconnect.ibm.com "mgmt" is invalid: spec.databaseBackup.credentials: Not found: "mgmt-backup-secret"
But I haven't created secrets for backup during install. Is this mandatory ? Any inputs ?
------------------------------
Raj A
------------------------------