List of Contributions

Hello Geoff. The FW B633 or B63Q are for the FRU 85Y6185 (code manufacturer ST9300653SS). The FRU 81Y9671 is not from the same manufacturer, as I can see in some photos on the internet, the manufacturer would be MK3001GRRB so the firmware is different. ------------------------------ Enrique Espinel ...

Hello. Model 12F, 24F, and 92F expansion enclosures are only supported for attachment to Models 524 and 624 control enclosure. Previous generation Storwize V7000 control enclosures (Models 112, 124, 312, and 324) do not support the attachment of Model 12F,24F, and 92F expansion enclosures. link: ...

Hello. In Storwize V7000 with version 7.8.X you should have no problem recognizing the disks. provided that these disks are among those supported by Storwize. Looking for FRU 81Y9671 I find no relationship with Storwize?? . I attached a capture of the label of that FRU FRU 85Y6185 ST9300653SS ...

Hi Geoff. maybe you could try create the satask.txt file on a USB flash drive.with only one line in it saying "setpwdreset enable" leave it for about 2 minute and it reports back a lot of information in a file called sainfo_result.html. look in this file if the status changed (password_reset_enabled ...

Hi Geoff You can try the following usual password variations for the superuser: Password Passw0rd (zero) Passw0rd. (zero) Pa $$ w0rd (zero) PASSW0RD (zero) Passw0rd! (zero) good luck ------------------------------ Enrique Espinel ------------------------------

Hello, I offered to perform a remote verification to see more about the problem. This is free of charge, it is simply a help, for 18 years I was an IBM technical specialist in Ecuador. my mail: eespinel@gmail.com ------------------------------ Enrique Espinel ------------------------------

Hi. The blue LED means that the device is ready to be removed from the enclosure You could try the following by the CLI interface on controller A 1. execute the cmgrSetAltToFailed command 2. Remove controller B wait 5 minutes and then reinsert it into the chassis. 3. run the cmgrSetAltToOptimal ...