IBM Security Verify

 View Only
  • 1.  RSA configuration restore

    Posted Wed September 14, 2022 09:34 AM

    Dear All,

    Recently for some reason we need to do some restoration and we recognized that RSA configuration was not restored from snapshot. 

    Is this the normal behavior?

    Shouldn't be restored RSA configuration too?

    We could do only a full reconfiguration for RSA on appliance and I would like to know whether is any other solution or not.


    Janos Laszlo Horvath

  • 2.  RE: RSA configuration restore

    Posted Wed September 14, 2022 11:07 AM



    The RSA configuration should definitely be included in the snapshot.  I am not sure of which version of ISVA you are currently running, but suspect that this was an issue at some point which has since been fixed.  Anyway, I would suggest that you raise a ticket with the IBM support team so that they can investigate further.




    Scott A. Exton
    Senior Software Engineer
    Chief Programmer - IBM Security Verify Access

    IBM Master Inventor

    cid4122760825*<a href=image002.png@01D85F83.85516C50">


  • 3.  RE: RSA configuration restore

    Posted Fri September 16, 2022 02:43 AM
    Hello Scott,

    Thanks for your answer.  Unfortunately I can tell you that it is not in Snapshot on version either and  At least not in our case.
     We do have case (TS010534768) but not so much solution yet.

    I surmise we may need some advanced tunning paramter to set.


    Janos Laszlo Horvath