Thank you. I needed to confirm if my approach was correct.
Original Message:
Sent: Fri July 26, 2024 08:12 AM
From: Javier Gavilan Lopez
Subject: I have a question about the zoning configuration of FS5200
Hello,
1 Yes, the root cause is missing paths.
2 Yes, in a redundant configuration, there should be the same number of paths to both controllers.
3 The reason probably is a cabling, zoning misconfiguration or both.
I've attached a simple schema based on that reflects your 'lstargetportfc' output. The problem is on the left fc switch (fc switch 1 on my table) zoning/cabling.
To simplify zoning, it's recommended to use peer zones. It's also unnecessary map all host ports to all controller ports. The optimal number of volume paths per host is four.
Regards.
------------------------------
Javier Gavilan Lopez
IT Director
COLABORATIC
Valencia
Original Message:
Sent: Thu July 25, 2024 02:14 AM
From: dongyong kang
Subject: I have a question about the zoning configuration of FS5200
------------------------------
dongyong kang
------------------------------