Hello
So I ran for test a validation on only one dbspace (dbsb), its size is 581 GB and it took apparently about 12 hours!!
Is this representing the time that a restore could take?
Just a question about the result… I can see "Data transfer Complete, total = 581776986112 bytes"
But I would expect "Data verification Complete…"
This means that all is OK?
ids1:/IDS/informix$onbar -v dbsb
onbar is starting ..........
Galaxy Instance: Instance001
Loading Library:/opt/commvault/Base64/libCvIbsad.so from dir /opt/commvault/Base64
Get object = /ids1/dbsb/0
Data transfer Complete, total = 581776986112 bytes
File /ids1/dbsb/0.1612897235.27085 Size = 581776986112 bytes, Informix I/O Time = 45812.253628 secs, MA I/O Time = 909.040381 secs, Total I/O Time = 46721.294009 secs,Informix Throughput = 42.577241 GB/Hr, MA I/O Throughput = 2145.734542 GB/Hr, Total I/O Throughput = 41.748830 GB/Hr
About the PSM, I have to start from here ?
https://www.ibm.com/support/knowledgecenter/en/SSGU8G_12.1.0/com.ibm.bar.doc/ids_bar_533.htm
Thanks
------------------------------
Sh To
------------------------------
Original Message:
Sent: Mon February 08, 2021 08:09 AM
From: Sh To
Subject: Validate backup : archecker –tdsv and CommVault
Hello,
I'd like to validate a backup with archecker ‑tdsv but in front of CommVault
If i run it as is i get
Error(2) opening tape device(/commv_dev/tmp0)
On the same machine, a table restore with commvault works with this command
Advanced Restore
archecker -Xbvs -f cmdfile
Does someone have an idea how to fit archecker ‑tdsv with Commvault ?
Thanks
------------------------------
Sh To
------------------------------
#Informix