we have several flash systems running in a PBR and PBHA configuration!

Does anybody know how to get Alerting out of SI when the Replication lines between two systems go down ?

We can see it in the Event Log of the system, but we don't get any messages out of SI pro.

Hi Mark, 
You can create a new alert definition on your SI Pro. I prefer to use Storage > Performance > Add Metrics > IP Workload (I'm using this for IP replication) > and select "Send" for IP Replication-to-Remote Node Data Rate (MiB/s). Add a metric of "<= 5 MiB/s" and save it. This will send an alert notification if your FlashSystem IP replication rate drops below 5 MiB/s. 

we have several flash systems running in a PBR and PBHA configuration!

Does anybody know how to get Alerting out of SI when the Replication lines between two systems go down ?

We can see it in the Event Log of the system, but we don't get any messages out of SI pro.

we have several flash systems running in a PBR and PBHA configuration!

Does anybody know how to get Alerting out of SI when the Replication lines between two systems go down ?

We can see it in the Event Log of the system, but we don't get any messages out of SI pro.

Hi Mark,

As of today, Storage Insights does not have any explicit alert policy for Replication. Hence we cannot define a specific alert definition for replication.

With upcoming release of SI we are adding following alerts around replication which would cover for PBHA and PBR in Storage Insights.

Default Policy:

• Replication status disconnected
• Replication status suspended
• Volume group deletion

Custom Policy for users to configure:

• RPO value >= user defined value

Regards,

Sushil Sharma

we have several flash systems running in a PBR and PBHA configuration!

Does anybody know how to get Alerting out of SI when the Replication lines between two systems go down ?

We can see it in the Event Log of the system, but we don't get any messages out of SI pro.