If the IMM network configuration as not been set correctly at the first install, you'll have to go onsite to configure it from the bios menu. If you already have access in ssh or by GUI and want to change the setting, you can refer to the guide below.
From GUI:
Select IMM management tab;
Select Network;
Enter your new Network info, and save changes.
A Restart of the IMM is required to apply these changes.
Onsite:
reboot server;
Press F1 when asked to sccess BIOS menu;
Select System Settings;
Select Integrated Management Module;
Select Network Configuration;
Enter your network settings and SAVE!!!
Exit BIOS menu, and your IMM should now be reachable.
Here's an old guide that will help you a lot. Most information like default user and password are still valid.
user: USERID
pass: PASSW0RD
(a zero 0, not the letter O)
ftp://ftp.software.ibm.com/systems/support/system_x_pdf/88y7599.pdf
Regards,
------------------------------
Anthony Gayadeen
------------------------------
Original Message:
Sent: 01-16-2018 05:53 PM
From: Matthew Carle
Subject: IMM Networking
How do you change the IMM Networking configuration for QRadar?