WebSphere Application Server & Liberty

WebSphere Application Server & Liberty

Join this online group to communicate across IBM product users and experts by sharing advice and best practices with peers and staying up to date regarding product enhancements.

 View Only

  • 1.  WAS/IHS 7.0.0.33 Installed, but console and versionInfo.sh show 7.0.0.29

    Posted Thu July 10, 2014 03:47 PM
    I'm attempting to install fixpaks to three application servers and two web servers for websphere 7.0.0.33 (WAS and IHS respectively) using the downloadable fixpack.  I began by downloading the neccessary fixpak for the Solaris operating system it's being installed on (Solaris 10  64). I also downloaded the latest installer fo v33.

    The installer was applied without issue, and as far as I can tell, I was able to install the fixpak as well, as every install has come back as INSTCONFSUCCESS in the install logs.  However, the administrative console and the versionInfo.sh still indicate that the installed version is 7.0.0.29.

    (I'm new to using forums, so if I'm leaving out any pertinent information, please let me know.  At this juncture, I'm hoping this is a simple issue with something I overlooked that perhaps I'm just not seeing)

    Additional info:
    Solaris 10 1/06 s10s_u1wos_19a SPARC
               Copyright 2005 Sun Microsystems, Inc.  All Rights Reserved.
                            Use is subject to license terms.
                               Assembled 07 December 2005




  • 2.  WAS/IHS 7.0.0.33 Installed, but console and versionInfo.sh show 7.0.0.29

    Posted Wed July 16, 2014 03:16 AM
    Hi Sean,

    I think you are using ND, request you to run manual synch from app server profile.

    After applying fix pack in console, we may find version miss match. Execute sych

    operation and let me know.


    Thanks,
    Chinna.


  • 3.  WAS/IHS 7.0.0.33 Installed, but console and versionInfo.sh show 7.0.0.29

    Posted Thu July 17, 2014 05:46 AM
    Hi sean,

      I make the same suggestion.

      Launch a full synchnode from console or manual synchnode from the nodes.

      Hope this helps. Tell us if you need more support.

    Regards


Related Content