After converting an Applinx 5 Path to a Path Procedure, there are steps that have Goto nodes. However, I cannot access or change these at all. Nor can I add a new Goto node. Do I assume that this is not allowed in Applinx8 and is only present because of the conversion?

Good afternoon, Joe!

You are correct, the ‘Goto’ nodes are only present because of the conversion of the old ApplinX 5 Path. It is impossible to create nor edit these nodes.

If you want to change the procedure by removing these nodes, it will be better to first back up, and do the changes carefully (replacing the ‘Goto’ nodes will probably change the entire logic of the procedure)

Yours,

Gad Salner