not easily no;some customers in the past have tried doing things like run a scheduled rule at certain intervals which would check the mq qm op state and snd an rmi request to toggle it up if it was down; but that has been shown to be a fragile solution
------------------------------
Matthias Siebler
MA
------------------------------
Original Message:
Sent: Tue July 22, 2025 02:29 PM
From: R K
Subject: MQ Handler in Datapower Not automatically updating
Thanks, But is there any way to make it auto enable or retrial after certain time in case the queue has been allowed
------------------------------
R K
Original Message:
Sent: Tue July 22, 2025 09:25 AM
From: Matthias Siebler
Subject: MQ Handler in Datapower Not automatically updating
My understanding is that this is expected behavior. If the MQ FSH or MQ QM object encounters a temporary network issue when trying to connect; it should retry, but if it sees that the Q is configured to disallow the get request; then it will not retry and wait for the manual touch to start again
(such as a object disable/enable )
------------------------------
Matthias Siebler
MA
Original Message:
Sent: Mon July 21, 2025 08:02 AM
From: R K
Subject: MQ Handler in Datapower Not automatically updating
Dears,
I have configured a MQ handler in Datapower listening to a specific queue. I have observed two issues while GET inhibiting the queue
1.If I enable the queue back, The Datapower MQ Handler is not updating automatically
2. I have added sharing conversations in Datapower QM Object , when I get inhibit the queue the complete QM object is going down and coming up after some time(atleast 10s)
Please let me know if there is any way to fix the issue.
------------------------------
R K
------------------------------