Originally posted by: jryan76

Hi,

I'm building a map based on the Delivery Confirmation v4 message in our Tradacoms industry pack. I'm trying to set up a simple validation map to check data etc but every file I load in fails with the following message:

Input valid but unknown data found

Input: 1 of 1
Objects: 22

Output: 1 of 1
Objects: 1

I've gone through the sample files I have and all come up with the same message. Looking at the tarce file there are a number of 'invalid' messages but none that specifically point me to what is invalid on the file. The file is valid so I think the type tree is incorrect but I don't know what needs to be corrected.

My trace file is attached. Any help would be greatly appreciated.

Thanks.
#DataExchange
#IBM-Websphere-Transformation-Extender
#IBMSterlingTransformationExtender

Originally posted by: NancyR

I am not familiar with that pack. If you look at the trace, the error is at offset 88.

If you post your map (including the type tree and source file) perhaps someone can figure out the problem.
#DataExchange
#IBM-Websphere-Transformation-Extender
#IBMSterlingTransformationExtender

Originally posted by: jryan76

Thanks for the response.

Sorry if this sounds like a dumb question but how do you know the error is at offset 88? There are many 'invalid' messages in the trace file so how have you pinpointed the error to this one?

Thanks.

John.
#IBM-Websphere-Transformation-Extender
#IBMSterlingTransformationExtender
#DataExchange

Originally posted by: jryan76

My project interchange is attached which includes the source file.

If anyone can help then thanks in advance!
#IBMSterlingTransformationExtender
#IBM-Websphere-Transformation-Extender
#DataExchange

Originally posted by: jryan76

My project interchange is attached which includes the source file.

If anyone can help then thanks in advance!
#DataExchange
#IBM-Websphere-Transformation-Extender
#IBMSterlingTransformationExtender

Originally posted by: NancyR

I think the problem is you are trying to run this map on a DataPower appliance. I don't believe the TRADACOMS pack is supported on that platform. When I changed the map to use the standard WTX engine, it ran fine.

For more information about reading the trace file you should look at the IBM Websphere Transformation Extender 8.2 Redbook: http://www.redbooks.ibm.com/redbooks/pdfs/sg247693.pdf.
#DataExchange
#IBMSterlingTransformationExtender
#IBM-Websphere-Transformation-Extender

Originally posted by: jryan76

The Tradacoms pack is valid on Datapower as we're running a number of different type trees from this pack on Datapower successfully. I see what you mean though - when I changed the MapRuntime to WTX is runs successfully.

Is there anything when runningin Datapower that would cause an error such as reserved characters?
#IBM-Websphere-Transformation-Extender
#DataExchange
#IBMSterlingTransformationExtender

Originally posted by: NancyR

The TRADACOMS pack may work on DataPower but I still do not think it is officially supported.
#IBM-Websphere-Transformation-Extender
#IBMSterlingTransformationExtender
#DataExchange