Cluster support is only available in Windows and Solaris, it's not available in Linux and AIX.
Multiple launchers for scalability and HA is supported in non-Cluster mode.
You have to open a ticket with support to see if this message can be removed. If not, you can make an enhancement request here.
https://watsonsupplychain.ideas.ibm.com/?project=ITXBased on all the questions you have, I suggest using IBM Support who can provide better assistance.
------------------------------
Rex Chan
------------------------------
Original Message:
Sent: Thu February 02, 2023 07:48 AM
From: Suriya Prakash
Subject: ISTX 10.1.1.1
Hi Team,
We have upgraded the launcher to 10.1.1.1. While starting the launcher using launcher.sh command we have been getting an information as below
"Launcher running under non-cluster mode "
I hope the above statement is just an information alone. Is there any option to disable the message. As we are not going to configure in cluster mode.
Thanks & Regards,
Suriya Prakash
------------------------------
Suriya Prakash
Original Message:
Sent: Wed February 01, 2023 03:53 PM
From: Rex Chan
Subject: ISTX 10.1.1.1
I assume you are running ITX in Launcher since this is where TM runs. In Linux, you can install the Launcher in any folder. In 10.x, the installing method is just extracting the installation file to that folder. You can have a 10.1.1 folder and you can have a 10.1.1.1 folder. As long as you are not running both Launcher at the same time, you should be fine; otherwise there will be port conflict.
------------------------------
Rex Chan
Original Message:
Sent: Wed February 01, 2023 11:48 AM
From: Suriya Prakash
Subject: ISTX 10.1.1.1
Hi Rex,
How about ISTX Runtime and Monitoring V10.1.1.1 for Linux. Because we have configured the server with 10.1.1.0 and now we would like upgrade the same.
Please advise on this.
Thanks
Suriya Prakash
------------------------------
Suriya Prakash
Original Message:
Sent: Wed February 01, 2023 11:31 AM
From: Rex Chan
Subject: ISTX 10.1.1.1
10.1.1.1 are not just patches. It consists of a full install. I would recommend uninstall 10.1.1 Design Studio and install 10.1.1.1. You can continue use the same maps developed in 10.1.1.
However in the future, if you go to 10.1.2 (newer version), it will be installed in a separate folder. So you could have 2 versions in the same Windows environment. In this situation, I keep the workspaces separate. I would copy the 10.1.1 (or 10.1.1.1) workspace to 10.1.2 workspace so you can continue to use the same maps and type trees. Once the maps and/or type trees are modified in the higher version, they may no longer come up in the older version.
------------------------------
Rex Chan
Original Message:
Sent: Wed February 01, 2023 07:18 AM
From: Suriya Prakash
Subject: ISTX 10.1.1.1
Hi Team,
We have been using ISTX 10.1.1.0 and would like upgrade to 10.1.1.1. Is that will an fresh installation or else we can apply the patches.
Please let us know on the same.
Thanks & Regards,
Suriya Prakash
------------------------------
Suriya Prakash
------------------------------
#DataExchange
#IBMSterlingTransformationExtender