I used to see this explanation on a Support page.
Now, I don't see such detail anymore.
Is skipsamebatch supported with 9.1.9?
Is "Setting skipsamebatch to 1" as described below the way to turn it on?
"This setting is used to slow down VScan when images are not always immediately available for processing.
If this option is selected, the thread memorizes the batch ID of the batch that it attempted to run last,
and does not immediately run it again. If the thread detects that the batch ID is not changed,
the thread delays before the next attempt to process.
The delay starts at 1 second, then doubles with each attempt up to a delay of 1 minute
(1 second, 2, 4, 8, 16, 32, 64, 64, 64, 64, 64 seconds).
If the thread detects that the batch ID is changed at any point, the delay is set back to 1 second.
On the Workflow tab, expand the hierarchy on the right and highlight VScan.
In the Settings section in the lower right, set skipsamebatch to 1.
Highlight the line labeled <dbs> above VScan in the thread hierarchy.
Set skipsamebatch to 1 there also.
Click Save, then go back to the Rulerunner tab and start the service."
------------------------------
dsakai
------------------------------