MQ

MQ

Join this online group to communicate across IBM product users and experts by sharing advice and best practices with peers and staying up to date regarding product enhancements.

 View Only

  • 1.  Inactive Sender Channel Question

    Posted 08/11/10 10:41 AM
    Inactive Sender Channel Question

    --------------------------------

    I have a situation where messages arrive at a queue manager and are immediately put into a remote queue for further transmission, but the sender queue is inactive and stays that way even though there are messages in the transmission queue. I get a call, check the channel to find it's inactive and I issue a start. This clears the logjam and it works for a time, but eventually the channel goes inactive again -- and won't start again even though messages are waiting to go out.

    The last error log entries for this queue manager were 2 weeks ago. I note that the /"Disconnect Interval/" for this channel is set at 6000, but I'm not sure if this is significant. The queue manager is not the only one on this server.

    Any ideas?

    --------------------------------

    Posted By: Cyberherbalist at Feb 23 2009 6:39PM


  • 2.  Inactive Sender Channel Question

    Posted 08/11/10 10:44 AM
    DISCINT 6000 sec implies channel will be stopped after 6000 sec of inactiveness.
    ALter the channel and make the DISCINT parameter value to /"zero/".

    Hope this will solve your problem.

    Regards,
    Madan Mohan B

    --------------------------------

    Posted By: madanmohan at Feb 24 2009 4:34PM


Related Content