IBM Guardium

IBM Guardium

Join this online user group to communicate across Security product users and IBM experts by sharing advice and best practices with peers and staying up to date regarding product enhancements.

 View Only

  • 1.  IBM I Series S-TAP not Successful

    Posted Fri September 10, 2021 02:01 AM
    HI Everyone,

    Running IBM I series (IBM i 7.3 - Db2 PTF Group SF99703 Level 22), it is the supported service level and STAP status is like below:
    When I opened /usr/local/guardium/install_out.txt, status is like below:


    But I dont see any Inspection engine detected in Guardium.
    Is the installation successful or not? What might be the issue?

    Thanks,
    Panendar Rao.C

    ------------------------------
    PHANENDRA RAO CHAVANA
    ------------------------------


  • 2.  RE: IBM I Series S-TAP not Successful

    Posted Fri September 10, 2021 05:44 AM
    Hi Phanendra,

    After the installation is complete:
    - Guardium attempts to start the processes that enable activity monitoring and to locate the InfoSphere Guardium collector using the IP address specified at the installation time.
    - Make sure PING RMTSYS('x.x.x.x') from IBM i to Guardium collector IP (x.x.x.x) is working (NOT connection refused or timeout)
    - Required ports on IBM i is opened. Port 16016 must be bidirectionally open in firewall
    •TCP 16016
    – UNIX STAP, both directions, registration, heartbeat, and data (including IBM i S-TAP running in PASE)

    Demi

    ------------------------------
    DEMI SIEW PING LEE
    ------------------------------

    Original Message


  • 3.  RE: IBM I Series S-TAP not Successful

    Posted Mon September 13, 2021 05:42 AM
    There is no inspection engine for iSeries S-TAP. This is different from open platform. But, you can use the DB2 i S-TAP Configuration and Status report to pull the information from i S-TAP.

    ------------------------------
    TS Teh
    ------------------------------

    Original Message


Related Content