Hello,

If I try to delete more then one profile I got an error like below - although I have no 'C4R' profiles in XFACILIT related with CLASS of my profiles to delete:


The zSecure Command Verifier exit does
not support multiple profiles.

DELDSD ('SYS2.TZSEC.AAAA*','SYS2.TZSEC.BBBB*','SYS2.TZSEC.CCCC*') GENERIC
C4R911W List of profiles not supported, all but first ignored.

Is it a correct message here ?
thx in advance


------------------------------
Regards
Sławomir Bujniak
------------------------------

Hi,

This message should never occur if zSecure Command Verifier is installed correctly. The only situations where it might occur is if you are running a very, very, very old release, or when the C4RPIER module cannot be found in steplib/linklist. You can test both, by issuing the C4RSTAT command. Expected output would be similar to

C4R982I Command Verifier is active                  
C4R971I EXIT version is 2.4.0                       
C4R973I PIER version is 2.4.0                       
C4R985I Resource class used for policy profiles is XFACILIT     
C4R976I Resource class is active                                
C4R969I Generic profiles are enabled                            
C4R978I Number of policy profiles is 105                        

Regards, Guus

------------------------------
Guus Bonnes
------------------------------

Hello,

Yes, thank you - the problem was related with linklist - the "SC4RLNK" lib was defined incorrectly.


------------------------------
Sławomir Bujniak
------------------------------

Original Message:
Sent: Mon February 10, 2020 11:40 AM
From: Guus Bonnes
Subject: Command Verifier - multiple profiles problem

Hi,

This message should never occur if zSecure Command Verifier is installed correctly. The only situations where it might occur is if you are running a very, very, very old release, or when the C4RPIER module cannot be found in steplib/linklist. You can test both, by issuing the C4RSTAT command. Expected output would be similar to

C4R982I Command Verifier is active                  C4R971I EXIT version is 2.4.0                       C4R973I PIER version is 2.4.0                       C4R985I Resource class used for policy profiles is XFACILIT     C4R976I Resource class is active                                C4R969I Generic profiles are enabled                            C4R978I Number of policy profiles is 105                        

Regards, Guus

------------------------------
Guus Bonnes
------------------------------