I created a new connector group with the option to disable automatic checkins. I ran the connector but am unsure where I go to verify and check in the table. I do not see an active DL service account workspace open which I would assume to be open to manually checkin. Does anyone have any info on this? Thanks. 

If the DL workspace didn't open, I would check to make sure the DL connector(s) ran without errors. Was the file path found? Did validation fail?

I just ran the connector group and still do not see the dl service account workspace. Not sure where the work is going while it is pending the checkin.

Check what Ben Foster said, also, are you sure it didn't get checked in.  If you have a group created but you select "Run Now" and not "Run All In Group Now", it will automatically check in the table.

Hi Vyacheslav Snitkovskiy,

To add to @Ben Foster and @Goga Moore, please check your data set in Studio for the last upload date and verify no one less had it checked out at the time it should have run. 

Check for the status of the connector is showing as "Success", if not the data fetch was not happened per the rule set while defining the connector. If success-> double check the destination project and BRANCH details if any.