Hi all,
Some of classes that I have defined on the CDT are not showing up on the RACF class settings display. They are working and they are listed on the SETROPTS LIST command. Any ideas why this may be happening?

------------------------------
Best Regards
Joao Bentes Jesus
------------------------------

Hello Jaoa
Do you have a CKFREEZE selected (through SE.1)?  If you do, the class settings are shown at the time of the snapshot (when CKFREEZE was created).  This is indicated by the date and time stamp in the top right corner of your ISPF display.
To get the current class settings:
- refresh the CKFREEZE, or
- unselect (U line command in SE.1) the CKFREEZE, and zSecure will show the active class settings

------------------------------
Rob van Hoboken
------------------------------

Hello Rob

That was just as you said. Now I will have to figure out why I was using to an old CKFREEZE.

Thank you for your quick help

------------------------------
Joao Bentes Jesus
------------------------------

Original Message:
Sent: Thu March 12, 2020 10:21 AM
From: Rob van Hoboken
Subject: Active classes not showing on RACF class settings display

Hello Jaoa
Do you have a CKFREEZE selected (through SE.1)?  If you do, the class settings are shown at the time of the snapshot (when CKFREEZE was created).  This is indicated by the date and time stamp in the top right corner of your ISPF display.
To get the current class settings:
- refresh the CKFREEZE, or
- unselect (U line command in SE.1) the CKFREEZE, and zSecure will show the active class settings

------------------------------
Rob van Hoboken
------------------------------