IBM Asset & Facilities Management Your destination for peer and expert insights to help unlock the power of data with AI and Asset & Facilities Management to advance your digital reinvention. Join / Log in
As a result of APAR IJ36787, a new map tool is available. You must be on Spatial 7.6.1 and have iFix 011 installed to use this new tool. The tool can be enabled for the Work Order Tracking application. When this tool is enabled, multiple pins will be displayed on the map tab for a single work order if the work order has tasks with an asset/location referenced that has geometry or if assets/locations are populated in the multi asset/location table that have geometry.
An example of a use case with screenshots below is a work order to take cathodic protection readings for test points. I have assets set up for the test points and linked with ESRI point features. I have one work order with 3 assets in the multi asset table. Each asset has its own linked ESRI feature. When I open the map tab I can see the new tool in the toolbar. I have the tool turned on and the option for viewing multiple symbols based on the multi asset location table. I can see 3 pins on the map since there are 3 assets with geometry on the work order.