Hello, apparently there is a change, there are two ways to do it, through the profile, it shows me the parameter that I need but it needs an ipl, and directly in the active partition, this parameter no longer shows it or at least I did not see it, I did it through the second option, thanks and greetings.
------------------------------
Miguel Peralta
------------------------------
Original Message:
Sent: Sun November 10, 2024 07:09 AM
From: Satid S
Subject: Bridging Between IBM i Host and IBM i Guest error CPDB1DB
Dear Miguel
When creating virtual ethernet resource 268C, did you follow the steps as described in this Technote? Adding a Virtual Ethernet (F/C268C) on HMC V7 or Higher at https://www.ibm.com/support/pages/adding-virtual-ethernet-fc268c-hmc-v7-or-higher If the look and feel of your HMC is different, you need to use common sense to navigate the new GUI while keeping in mind that the core process should not changed.
------------------------------
Satid S
Original Message:
Sent: Sat November 09, 2024 05:24 PM
From: Miguel Peralta
Subject: Bridging Between IBM i Host and IBM i Guest error CPDB1DB
Hello, I am creating a bridge between IBM i Host and IBM i Guest, using the link
Ethernet Bridging Between IBM i Host and IBM i Guest
| Ibm | remove preview |
 | | Ethernet Bridging Between IBM i Host and IBM i Guest | | This document outlines the setup of an IBM i Host and IBM i Guest using Ethernet Bridging. | | View this on Ibm > |
|
|
But when I vary on it sends the following message CPDB1DB:
--00002090: Unable to enter promiscuous mode for an Ethernet port that
was intended for layer-2 bridging. For virtual Ethernet (type 268C) ports,
this indicates that the selected virtual Ethernet adapter was not specified
to allow bridging at the management console interface. For Host Ethernet
Adapter ports, this may indicate that the port was not marked as being
promiscuous-enabled at the management console interface. Otherwise, this
may indicate a hardware problem.
--00002090: Use the Change Line Desc (Ethernet) (CHGLINETH) command to
change the Resource name (RSRCNAME) parameter for line &23 to a valid value
or use the management console interface to correct the configuration
problem.
The server and its HMC are very new. Could it be that the way of configuring C268C has changed?
Regards.
------------------------------
Miguel Peralta
------------------------------