Hi Moshe,
There is no System IP before initial configuration. The very first proper configuration command you run is mkcluster (or create system) and that accepts the system IP as a required parameter.
See https://www.ibm.com/docs/en/flashsystem-5x00/8.4.x?topic=cs-initializing-system-technician-port-3
and
https://www.ibm.com/docs/en/flashsystem-5x00/8.4.x?topic=stc-mkcluster-7
As I mentioned before, you cannot edit the technician port IP, that is a fixed local/point to point IP.
You can at any time change the serviceip of a node using the Service Assistant GUI or the service CLI.
So there are 2 times/places you can configure the System IP or cluster IP.
1: at cluster creation (which is system initialization workflow)
2: at any point after cluster creation using the change management IP workflow or the chsystemip command line.
I hope that helps.
https://www.ibm.com/docs/en/flashsystem-5x00/8.5.x?topic=stc-satask-chserviceip
In the GUI you select the node or node canister you want to edit based on it's name or panel id, and go to the Change Service IP panel or menu item (dependent on the version of code in use the flow differs).
------------------------------
Evelyn Perez
IBM Senior Technical Staff Member
IBM Storage Virtualize Software Architect for SVC and FlashSystem
------------------------------
Original Message:
Sent: Sun March 17, 2024 02:44 AM
From: Moshe Bezalel
Subject: FC5200 Initial configuration
Hi
I know to change it on the GUI after I finish the Initial configuration
I want to do it before I start the Initial configuration
------------------------------
Moshe Bezalel
Original Message:
Sent: Thu March 14, 2024 03:28 AM
From: Nezih Boyacioglu
Subject: FC5200 Initial configuration
go to settings > network > management ip addresses and change it
------------------------------
Nezih Boyacioglu
Original Message:
Sent: Thu March 14, 2024 03:08 AM
From: Moshe Bezalel
Subject: FC5200 Initial configuration
Hi
I connect first time to technician port and finish configure the cluster IP address of the FS5200
Before I start to Initial configuration the customer want to change the cluster IP Address
How I can change it before I start the Initial configuration ?
------------------------------
Moshe Bezalel
------------------------------