Originally posted by: SystemAdmin

Question:

How to move a RG HACMP belonging to node2 on the node1 while node2 is offline ?

Thank's
#AIX-Forum

Originally posted by: orphy

Check out clRGmove in the Admin Guide.
Orphy
#AIX-Forum

Originally posted by: alethad

What do you mean by node2 is offline? Do you mean the node is down or that just HA is not running?
#AIX-Forum

Originally posted by: alethad

Here's the link to the redbook. Look at page 233.
http://www.redbooks.ibm.com/redbooks/pdfs/sg246375.pdf
The resource group has to be online and not in an error status. You didn't specify which node the RG is. If it's on node2 and node2 is offline then you can't move it.
Good luck.
#AIX-Forum

Originally posted by: SystemAdmin

Thank's for all.

alethad,

The RG belong to node2 but node2 (server) is offline. There is no way to resume the RG on node1 ? Suppose that the server (node2) is down and we want to resume its resources on the other node. What can be done in this case ?

HACMP must turn on the node2 to take its resources ?

Regards

Message was edited by: screendz
#AIX-Forum

Originally posted by: alethad

That's kinda the whole point of running HACMP. Both nodes have to be up for HA to do the take over for you. Or the RG move for you. Otherwise you will have to do it mannually which is more than a pain in the butt if you need more that just the volume groups varied onto node1.
You'll have to get HA started on node2. I hope you've got your HA config verfied and synchronized before node2 went offline. Not sure what your circumstances are so it's a little hard to tell you what to do next.
Good luck.
#AIX-Forum

Originally posted by: orphy

Have you looked at clRGmove yet? clRGinfo might also be helpful to you.

http://publib.boulder.ibm.com/infocenter/clresctr/vxrx/index.jsp?topic=/com.ibm.cluster.hacmp.doc/hacmpbooks.html
Orphy
#AIX-Forum