Hi All,

I’m setting up AS2 exchange between the IS and our partner. However, the partner is receiving the transmission without the AS2 headers in the HTTP header.

The versions: IS 7.1.2, TN 7.1.2, EDI 6.5.2, EDIINT 6.5.2

I’ve done according to the 6-5-2_EDIINT_Module_Users_Guide.pdf:

• set up the sender TN Profile (loaded the certs, set up the priv key, set up the Extended Fields, set the “EDIINT AS2” External ID to match the AS2 ID);
• set up the same for the receiver;
• defined the Delivery Mode to Primary HTTPS;

The partner is receiving the transmission, meaning that the communication is being established. However, the HTTP header is not okay.

I’ve found a thread about AS2 headers missing from the MDN headers ([url]wmusers.com) - not sure if that has any relationship with this.

Any help will be greatly appreciated.

Best regards

make sure your outbound delivery service is wm.EDIINT:send, it will create the ENIINT envelope and put into the delivery service (wm.EDIINT.rules:sendMsg). If you are missing AS2 header, then EDIINT envelope is not constructed properly.

Tong,

Thanks for the reply.

I assumed (wrongly btw) that configuring “deliver document by” the “receiver’s preferred protocol” was enough to have the AS2 headers in the HTTP header.

I built a wrapper around the wm.EDIINT:send service, registered it as a delivery service and the set the processing rule’s delivery to be immediate delivered by the new delivery service.

Thanks for pointing the right direction.