Then I'm afraid it's time for a support case (and for upgrading to a supported version anyway).
This situation might require closer inspection than what's possible on this forum.
Original Message:
Sent: Wed February 15, 2023 09:53 AM
From: Jaco Loots
Subject: Replication disconnect and reconnect to server
on both the impacted servers it says disconnect and reconnect.
No replication not working on the 2 servers
------------------------------
Jaco Loots
Original Message:
Sent: Wed February 15, 2023 09:44 AM
From: Andreas Legner
Subject: Replication disconnect and reconnect to server
So what's the other side saying, in its message log?
Replication working properly between the two servers and between the disconnects?
------------------------------
Andreas Legner
Original Message:
Sent: Tue February 14, 2023 12:49 PM
From: Jaco Loots
Subject: Replication disconnect and reconnect to server
Thank you
Informix is at version 11.70 FC8.
it happens every 4 to 5 min it a constant disconnect and reconnect and at any time of the day.
yes when running the CDR utility on server1 (grp_08_headq) to server 2 (grp_23_north) and visa versa.
if you run same utility on server 3 to 1 everything 100% even to server 2.
there is a total of 12 server but only those 2 started with this issue
------------------------------
Jaco Loots
Original Message:
Sent: Tue February 14, 2023 10:36 AM
From: Andreas Legner
Subject: Replication disconnect and reconnect to server
First of all, welcome to the group!
Immediately next: what version(s) are we talking about?
Then: any time pattern possibly, with those disconnects and/or reconnects? Any coincidence possibly with e.g. load on one of the two disconnecting servers?
Finally: "cdr stop repl" should not depend on servers' connection status (it works locally only and creates request messages for work to be done on other servers, but wouldn't wait on their feedback.) So something else might be going on ...
What exactly do you mean by "cdr stop repl *** from server 1 to server 2" vs. "... from all the other servers"?
Is it: you're running the cdr utility on server 1 using "--connect server2"? With servers 1 + 2 being the ones disconnecting (so server 2 being grp_23_north)?
BR,
Andreas
------------------------------
Andreas Legner
Original Message:
Sent: Tue February 14, 2023 09:40 AM
From: Jaco Loots
Subject: Replication disconnect and reconnect to server
Good day
I'm new to the community.
i have this issue on Enterprise Replication between 2 servers.it just started no change to the system. if you do cdr list serv all servers is connected but if you check in the online log it keeps on saying server 1 disconnect and then reconnects again. no replication is happening to the 2 servers. all the other servers is working fine no problem. if you say issue a cdr stop repl *** from server 1 to server 2 it takes about 5 min to stop the repl. from all the other servers its instant stop.
11:36:45 CDR connection to server lost, id 23, name <grp_23_north>
Reason: connection lost
11:37:39 CDR: Re-connected to server, id 23, name <grp_23_north>
------------------------------
Jaco Loots
------------------------------