Hi Peter,
I believe that depends on what you specify in SETUP RUN (SE.0).
For example, I have:
zSecure Suite - Setup - Run
Command ===> _________________________________________________________________
Enter "/" to select run option(s)
/ Use permanent work data sets (CKRCMD is always permanent)
_ Delete permanent work data sets on exit
/ Allocate previous input files at startup
So in my setup that is indeed the expectation.
Here is one of the help panels:
Delete permanent work data sets on exit
When "Use permanent work data sets" is selected, the user interface
allocates six work data sets for the dialog:
workpref.C2Rn<iiii>.CKRCMD
workpref.C2Rn<iiii>.CKR2PASS
workpref.C2Rn<iiii>.CKRTSPRT
workpref.C2Rn<iiii>.REPORT
workpref.C2Rn<iiii>.SYSTERM
workpref.C2Rn<iiii>.SYSPRINT
For efficiency reasons, these data sets are not deleted when you are
finished with the dialog. You should select this option when security or
space management considerations require that you delete these data sets
after leaving the interface.
Note that the CKRCMD data sets are only deleted if you select the
suboption "Delete CKRCMD on exit" under the CKRCMD settings in the SETUP
OUTPUT menu as well.
Regards,
------------------------------
Jeroen Tiggelman
Software Development and Level 3 Support Manager IBM Security zSecure Suite
IBM
Delft
------------------------------
Original Message:
Sent: Thu January 26, 2023 02:56 AM
From: Peter Karel
Subject: ISPF CKR sessions RESULT datasets are not deleted on Ending ISPF session.
Hi,
I always have "dead bodies" lying around from zSecure ( like the one below) , and have to clean them up manually.
Is this normal behaviour ?
???.C2R1F80.CKRCMD
???.C2R1F80.CKRTCMD
???.C2R1F80.CKRTSPRT
???.C2R1F80.CKR2PASS
???.C2R1F802.CKRCMD
???.C2R1F803.CKRCMD
???.C2R12FF.CKRCMD
???.C2R12FF.CKRTCMD
???.C2R12FF.CKRTSPRT
???.C2R12FF.CKR2PASS
???.C2R12FF2.CKRCMD
???.C2R12FF3.CKRCMD
Kind Regards,
Peter
------------------------------
Peter Karel
------------------------------