IBM Security SOAR

Expand all | Collapse all

How long should resDrStatus take to run?

  • 1.  How long should resDrStatus take to run?

    Posted Thu May 20, 2021 10:21 AM
    I am following the IBM documentation to upgrade our DR system at https://www.ibm.com/docs/en/rsoa-and-rp/38?topic=playbooks-disabling-resilient-dr and that involves
    disabling resilient:
    sudo systemctl disable resilient
    Stopping resilient
    sudo systemctl stop resilient
     
    And sync'ing master with receiver applicance
    sudo bash resDrStatus -w

    How long should the resDrStatus command take?

    ------------------------------
    Tim Gray
    ------------------------------


  • 2.  RE: How long should resDrStatus take to run?

    Posted Fri May 21, 2021 02:13 AM
    Hi Tim,

    resDrStatus doesn't sync the two servers, it checks that they are both in sync, see https://www.ibm.com/docs/en/rsoa-and-rp/38?topic=monitor-viewing-status-from-command-line. You can run that command when the two servers are in normal operations to ensure they are both in sync. If with -w it doesn't complete it likely indicates that the two servers are not in sync.

    You should tackle that problem before commencing. See https://www.ibm.com/docs/en/rsoa-and-rp/38?topic=guide-using-health-monitor which suggests, depending on the output from the command, that you may need to check on the status of the filesync service as one of the possible next steps.

    ------------------------------
    BEN WILLIAMS
    ------------------------------