IBM Security Guardium

 View Only

  • 1.  Data level Policy installation issue from CM to Collector

    Posted Tue December 15, 2020 05:06 AM
    Hi Everyone,

    I am getting below error when I create a policy from CM and install it to the Collector. Please help me out of this.
    Eventhough I have got that error, I am able to see the respective policy is installed at the collector end from CM.


    Thanks,
    Panendar Rao.C


    ------------------------------
    PHANENDRA RAO CHAVANA
    ------------------------------


  • 2.  RE: Data level Policy installation issue from CM to Collector

    Posted Tue December 15, 2020 05:51 AM
    Hi Phanendra,

    Without digging into this too much I would suggest reviewing this documentation: https://www.ibm.com/support/knowledgecenter/SSMPHH_11.2.0/com.ibm.guardium.doc/protect/Guardium_11.2_SR_language.pdf

    If this doesn't help then I would recommend raising a case with the IBM Guardium Support team who should be able to research this problem for you.

    ------------------------------
    Chris Beaney
    Data Security Support Manager - Europe, Middle East & Africa
    IBM
    ------------------------------

    Original Message


  • 3.  RE: Data level Policy installation issue from CM to Collector

    Posted Wed December 16, 2020 08:22 AM
    Edited by Miguel Garcia Gimenez Wed December 16, 2020 08:23 AM
    Hi Phanendra,

    as probably you will know, the sniffer process is the Guardium process that analyzes and parses all incoming traffic from S-TAP.

    Session-level policies are evaluated at the beginning of the sniffer process, e.g. firewalling policies. On the other hand, data-level policies are evaluated at the end of the sniffer process. This is why session-level policies have to be installed before data-level policies.

    Regards.

    ------------------------------
    Miguel Garcia Gimenez
    Cibersecurity Expert at Nologin Consulting S.L
    IBM Partner
    ------------------------------

    Original Message