DataPower

 View Only

  • 1.  Unable to capture Error Payload and status code on DPOD

    Posted Mon October 03, 2022 06:41 AM
      |   view attached
    Hi all,

    we are unable to capture Error Payload and status code on DPOD.
    Please find attached a screenshot.

    ------------------------------
    Anant Ghadi
    ------------------------------


  • 2.  RE: Unable to capture Error Payload and status code on DPOD

    Posted Tue October 04, 2022 02:54 AM
    Edited by Amit Munwes Tue October 04, 2022 02:54 AM
    Hi,
    1. Did you follow these steps (also note the types of supported services at the top of that page)?
      https://montier.atlassian.net/wiki/spaces/DPOD011800/pages/15731264723/Configure+WS-M+for+Payload+Capture
    2. Did you create a WS-M subscription?
      https://montier.atlassian.net/wiki/spaces/DPOD011800/pages/15731264863/Payload+Capture


    ------------------------------
    Amit Munwes
    ------------------------------

    Original Message


  • 3.  RE: Unable to capture Error Payload and status code on DPOD

    Posted Tue October 04, 2022 02:58 AM
    DPOD cannot capture the HTTP status code that was returned to the client (this information is not available out-of-the-box from the DataPower gateway).
    However, you can add your own XSLT/GatewayScript and write a log message with the HTTP status code, which will be collected in DPOD and will be visible in the "Raw Messages" tab of each transaction.

    ------------------------------
    Amit Munwes
    ------------------------------

    Original Message