From: Timothy Bryant via IBM Community [mailto:Mail@ConnectedCommunity.org]
Sent: 20 June 2018 14:03
To: Rab McGill
Subject: RE: IIB V10 Remote trace
The following message has been sent to you in response to your Discussion message
Message From: Timothy Bryant
Looks like the V10 Knowledge Center wasn't updated with the changes to the IIB Toolkit.
I believe your only option to control tracing on a remote server, without providing command line access, would be to write a CMP application that your developers could call to control that.
Most of the CMP functions have been migrated to the new REST interfaces, however I wasn't able to find the REST equivalent to control tracing.
------------------------------
Timm Bryant
------------------------------
-------------------------------------------
Thanks for the confirmation Timm
Rab.
------------------------------
Rab McGill
------------------------------
Original Message:
Sent: 06-15-2018 09:56
From: Rab McGill
Subject: IIB V10 Remote trace
Hi,
According to the Knowledge centre
https://www.ibm.com/support/knowledgecenter/en/SSMKHH_10.0.0/com.ibm.etools.mft.doc/an01310_.htm
"You can also use the IBM Integration Toolkit to start and stop tracing on remote systems."
I can not see a way to start a trace at all from the V10 toolkit.
Basically I want developers the ability to run
mqsichangetrace
mqsireadlog
mqsiformatlog
etc on a remote IIB Windows server. I have access to the server and can run the commands but the developers don't. Is there a way for them to set tracing themselves?
------------------------------
Rab McGill
------------------------------