Open a syntax file and run the command:
SET PRINTBACK=LISTING.
then try your commands again., You should see the commands that were run echoed back to Output window. Maybe that will help....?
Also, consider adding TITLE and SUBTITLE commands to your syntax, if you haven't already done that.
------------------------------
Rick Marcantonio
Quality Assurance
IBM
------------------------------
Original Message:
Sent: Mon November 08, 2021 08:41 AM
From: johannes achenbach
Subject: Ouput window not showing Split / Select / etc. actions
Dear Forum,
unfortunately, I strongly suspect my own inaptitude as the culprit. However, I cannot seem to make SPSS show me split / select / or similar operations in the output window thus making it hard to keep track on which file and which case subsets operations are performed on.
Maybe someone can point me in the right direction?
Cheers for the input,
J.
------------------------------
johannes achenbach
------------------------------
#SPSSStatistics